![]() |
The Classification toolbar in the PARTdataManager gives you the opportunity to continue to easily manage your catalog after a successful initial installation of your own catalog (see Section 3.1, “ Classimporter ”).[14]
You have the following commands at your disposal:
[14] Prerequisite:
In the configuration file under $CADENAS_SETUP/classification_toolbar.cfg
,
the key "Initialize" has to be set on the value '1'.
Data to create
an example very easy can be found under $CADENAS/training/classimporter
. The
readme.txt in the same directory is a small guide with a few
steps.