English
Deutsch
Español
Français
Hrvatski
Italiano
Polski
Türkçe
Русский
中文
日本語
한국어
Legal notice
powered by CADENAS

Manual

Top Links

Manual

3.6. Simulation
3.6.3. Simulation - Specification for Mechatronics Concept Designer (MCD)
Prev   Next

3.6.3. Simulation - Specification for Mechatronics Concept Designer (MCD)

3.6.3.1. Rotative and linear simulation (MCD)
3.6.3.1.1. Example for a linear simulation with a FESTO ADN compact cylinder
3.6.3.1.2. Example for a rotative simulation with an AFAG RE-50 rotary module
3.6.3.1.3. Test the simulation in the Mechatronics Concept Designer
3.6.3.2. Simulation for Sensors and Conveyor belts (MCD)
3.6.3.2.1. Conveyor belts
3.6.3.2.2. Sensors
3.6.3.3. Limits of joints (MCD)

[Note] Note

Make sure that following settings are made under $CADENAS_SETUP/ifugnx.cfg -> Block [CreationOptions]:

  • EnableMCD = 1

  • CreateMCDCAMProfiles = 1

  • CreateMCDContainers = 1

[Note] Note

This explanation on the Mechatronics Concept Designer (MCD) is just a rudimentary test instruction serving only for the purpose to check if the parts are specified correctly in the electronic product catalog. A detailed training and documentation about the Mechatronics Concept Designer is not provided by CADENAS.

Prev  Up  Next
3.6.2. Supported Systems  Home  3.6.3.1. Rotative and linear simulation (MCD)