English
Deutsch
Español
Français
Hrvatski
Italiano
Polski
Türkçe
Русский
中文
日本語
한국어
Legal notice
powered by CADENAS

Manual

Top Links

Manual

1.1.7.5.11. windowsettings_....cfg
1.1.7.5.11.2. Definition of window distribution in the PARTdataManager
Prev   Next
1.1.7.5.11.2. Definition of window distribution in the PARTdataManager

The following explains the syntax in detail with example images:

  • Block names

    The block names described the different parts modes in the PARTdataManager.

    For each part mode the window distribution is determined individually.

    The following list contains all possible part modes.

    • prt: 3D single part

    • ass: Assembly configuration (in selection mode) or template

    • assconf: Assembly configuration (in Configuration mode)

    • asstabconf: Assembly-Table-Configuration

    • dbs: 2D single part

    • native3d: Native 3D part

    • native: Native part without 3D view

    • nocad: Part without geometry

  • Key names

    The key names described the different windows in the PARTdataManager in each mode.

    Depending on the part mode, only certain windows appear.

    The following list contains all possible key names (=dialog windows).

    • assembly: Dialog window Assembly (Part List)

    • table: Dialog window Table

    • dlg3d: Dialog window Settings for 3D part

    • dlgdbs: Dialog window Settings for 2D part

    • dlgnative: Dialog window Settings for native 3D part

    • viewdbs: Dialog window 2D view

    • view3d: Dialog window 3D view

    • preview: Dialog window Technical details

    • crossref: Dialog window Links

    • configuration: Dialog window Configurator

  • Values

    The value indication corresponds to the following logic:

    • 1st value: x coordinate of left top window corner

    • 2nd value: y coordinate of left top window corner

    • 3rd value: x circumference of window

    • 4th value: y circumference of window

    Enter the 4 values separated by commas.

    The specification corresponds to a percentage value. (Only enter numeric values, no percent symbol)

    Optionally you can work with decimal places. Maximum 2 places are allowed.

    If all 4 values are set to '0', the window will not be displayed.

Example:

Definition of Assembly dialog window in PARTdataManager mode Single part:

[prt]
assembly=0,0,15,57

Prev  Up  Next
1.1.7.5.11.1. Basic settings  Home  1.1.7.5.11.3. Examples