Manual

Our 3D CAD supplier models have been moved to 3Dfindit.com, the new visual search engine for 3D CAD, CAE & BIM models.

You can log in there with your existing account of this site.

The content remains free of charge.

6.9.3.10.1. Insert Chamfer/Fillet... 6.9.3.10.1.4. Using "Base surface" feature
Prev	Next

The top circular edges of a cut cuboid shall be rounded.

	Note
Selecting the four top circular edges is not possible, because these are construction edges. Construction edges occur when adding geometries. Construction edges may also be used for a "Blend"; however, by using the intersection of faces not by using single edges.

Note

Selecting the four top circular edges is not possible, because these are construction edges.

Construction edges occur when adding geometries.

Construction edges may also be used for a "Blend"; however, by using the intersection of faces not by using single edges.

Select all side faces of the inner cuboid and the upper face (multi selection with Ctrl key).

Click on the context menu command New Chamfer/Fillet....

-> The dialog Chamfer/Fillet is opened.
Select Fillet and the desired Radius.

When leaving the remaining settings now and clicking OK, the note "Assembly" cannot be created" is displayed.

Note

The blend operation creates geometry with different convexity.

Solution: Enable the checkbox Base surface and in the list field, select Base extrude 1: Vorderseite.
Now confirm with OK.

-> The roundings are set.

Prev	Up	Next
6.9.3.10.1.3. Expand existing blend feature	Home	6.9.3.10.1.5. Overlying blends