powered by CADENAS

Manual

Manual

5.13.10.13.9.  Mounting Point (CNS_CP|4|6)

Mounting Point defines at which points of the component other components can be mounted (e.g. also accessories).

Select the desired connection point and classify it as Mounting Point. (Concerning point selection and calling the command compare under Mounting Description.)

Fill out the attribute values as usual, especially also the attribute value Description (compare above).

[During the training period it is OK, if the description is just the name of the Mounting Point, for example. However, if devices shall be mounted at others you have to regard the above mentioned instructions.]