powered by CADENAS

Manual

Manual

2.2.5.1.1. Material name from the table
[Note] Note

This variant is not recommended (however, for the sake of completeness mentioned), because additionally created columns will get lost by a catalog update.

In the following exemplifying figure, the additional column for the material is named "MAT_X".

Via PARTdataManager -> Table menu -> Edit -> Create tables dialog box -> Table tabbed page, you can insert materials.

Additional column "MAT_X" in the 23d-libs table

Additional column "MAT_X" in the 23d-libs table

[Note] Note

In order for the CNS classification to use the correct column, please make the respective adjustment under PARTadmin -> Category -> Configuration files -> $CADENAS_SETUP -> if<cadname>.cfg -> Block CreationOptions(is3d) -> Key Material.[a]

The figure exemplifies the selection of adeskinv.cfg

The figure exemplifies the selection of adeskinv.cfg

[a] In the example in hand "CNSMAT" has to be changed to "MAT_X".