powered by CADENAS

Manual

Manual

5.13.10.15.12. Most frequent error sources

Although the CNS classification system does not provide any possibility for validation, in combination with target systems (especially Zuken E3) a quite broadly verification can be performed. The procedure described in the following will also be possible in the pipeline at a later time. This chapter describes the most frequent error cases and their diagnosis for cases manually and automatically (Pipeline) classified.

Our approach on debugging new classified parts: 1. Open part in PARTdataManager. 2. Export via Zuken interface. 3. Analysis of output directory of Zuken interface. These steps will be covered in the following by using the most frequent error cases:

At this the essential component is the E3Components.xsd (ifaces/zuken) provided by Zuken, through which the created target format will be validated: