Search results of a Topology search are displayed on the respective tabbed page as usual. The tab shows the respective icon .

The following figures show the results of a combined search for "hexagon bolt" (Full-text search ) and the topological features Size and Cylinder.

Topology search for Size and Cylinder

At Topology search found values are colored and displayed in the corresponding table column.

Table columns corresponding to topological attributes are automatically displayed.

Features such as cylinder, cone, etc., where Topology search is searching for, are colored in the tooltip of search results. See above figure.

Load results into the Part comparison

Display in Part comparison:

By default, the display of topological information in Part comparison is disabled. However, if search results of a Topology search are opened, the topological attributes under Tabular Compare are already marked, the respective checkboxes already selected and so the respective information in the 3D comparison displayed as well.