Our 3D CAD supplier models have been moved to 3Dfindit.com, the new visual search engine for 3D CAD, CAE & BIM models.
You can log in there with your existing account of this site.
The content remains free of charge.
1.3.4.5.2. Context menu commands in detail
1.3.4.5.2.2.
Geometrical search index for Partial search
|
|
---|---|
Prev | Next |
The Partial search is activated by default.
However, the Partial search needs special fingerprints. The standard creation of the Geometrical search index is not sufficient. At first you have to set an entry in a configuration file.
For example, to
create the fingerprints for the catalog "mycatalog", in the configuration
file under $CADENAS_SETUP
-> geomsearch.cfg
set the following
key:
PartialSearchCatalogs=cat/mycatalog
If you want to specify more than one catalog, enter other entries separated by comma.[8]
This setting applies for each way of creation of fingerprints.
Finally create the Geometrical search index for the whole catalog.
How to know if partial search indexing is done?
Open PARTadmin with category Index administration.
Catalogs with available index show the respective icon .