powered by CADENAS

Manual

Manual

5.9.3.2.  3D models

[Note] Note

The declaration of at least one 3D model is obligatory! Optionally you may also declare several 3D models via Variants.

Under File with 3D model, in the row (none), select the desired 3db file in the list field.

[Note] Note

At many bolts (especially in the Standards catalog, but not only) there are two Modes (Nominal thread and Core diameter). However, in such cases, in PARTdataManager, only Nominal thread is displayed! Core diameter is not used anymore!

For new catalogs always Nominal thread is created by default!

Modes "Nominal thread" and "Core diameter"

Modes "Nominal thread" and "Core diameter"

In general applies: If no 3db file is stated, in TestMeta, in the dialog box QA check, a respective error message is displayed.