powered by CADENAS

Manual

Manual

2.5.6.2.6. Several Inventor versions in parallel operation

If you are operating several Inventor versions, you must note the following:

  1. All relevant interfaces must be installed.

    Example: Several Inventor interfaces installed in parallel

    Example: Several Inventor interfaces installed in parallel

  2. Before starting the respective Inventor version, the corresponding interface must be activated by carrying out the file register.bat in the respective sub-directory of the installation.

    For example, the file is located under $CADENAS/iface/inventor/2010_32.

    Carry out register.bat

    Carry out register.bat

  3. -> If the registration was successful, you will receive a corresponding message.

    Message: Registration successful

    Message: Registration successful