powered by CADENAS

Manual

Manual

2.5.6.2.2. Insert connections from PARTsolutions

In the Connection section you can determine via button , whether holes also have to be transferred to the CAD.

The following figure shows the selection of a hexagon bolt and the selection of hole ISO 273f at bolt and nut side.

Connection with holes

Connection with holes

In Inventor, in the tree view you can see the difference: At bolt 1 the hole has been transferred in addition, at bolt 2 not.

If you hide the bolts you can see the difference in the 3D depiction.

Under Section 2.6.10, “ Insert Connection ” you can find a general description of the Connection section.

Detailed information on the Connection section is found under Section 3.1.1.10.4, “User interface in detail ”.