powered by CADENAS

Manual

Manual

3.1.1.6.10.  Part comparison

The docking window (tabbed page) Part comparison shows the tabbed page Tabular Compare on the left side and the tabbed pages 3D comparison and 2D comparison on the right side.

  • All projects that are loaded into the part comparison show up in the Tabular Compare section.

    [Note] Note

    The part comparison can support up to 10 opened projects.

  • Via the context menu command Load as first project or Load as second project in the Tabular Compare section (see Fig. „ Tabular Compare - Context menu commands“ you can load or change the parts to be compared in the 3D comparison and 2D comparison sections (if more than two were loaded into the tabular compare).

  • Under Tabular Compare, when clicking on the icon Select project line , you can open the table and adjust the characteristics.

  • You can geometrically compare in the sections 3D comparison and 2D comparison.