powered by CADENAS

Manual

Manual

5.2.5.3.  Configure linear system

[Note] Note

This command can only be found in the context menu and only for part type linear system.

When adding linear systems you can launch settings dialogs with the button Configure linear system.

Click on that button.

Configure linear system

Configure linear system

--> The part specific settings dialog is opened.

Open/close the desired areas via the +/- buttons or in the context menu. Via the context menu you can then additionally maximize the respective settings area.

Settings

Settings

[Note] Note

The option fields highlighted in red mean that for some entry other settings options have been affected.

During "Mouseover" you receive the corresponding information in the tooltip.

Tooltip

Tooltip

[Note] Note

All setting can be carried out via the PARTsolutions table as well.

Table selection - enter value

Table selection - enter value