powered by CADENAS

Manual

Manual

3.1.3.1.6.2. Extended 3D toolbar

The 3D toolbar View modes can be connected the standard 3D toolbar in the 3D window.

Right-click onto any toolbar and select View modes in the context menu.

View modes toolbar

View modes toolbar

The following table describes the individual icons.

Line view

All lines visible.

The button can be found in both toolbars.

Hidden lines gray display

Line display with hidden edges.

This button only exists in the toolbar View modes.

Hidden line view

Line display without hidden edges.

This button only exists in the toolbar View modes.

Shaded view

Volume body display with shadow at body.

The button can be found in both toolbars.

Shaded view with edges

Volume body display with shadow at body and contour lines.

The button can be found in both toolbars.

Red/green effect

With 3D glasses, the part can be seen spatially.

This button only exists in the toolbar View modes.

Display with shadow

Volume body display with shadow created by body.

This button only exists in the toolbar View modes.

Show connection points Selection list to possibly show, hide existing connection points in/at part, just show active connection point
Display published elements or show/hide text attributes  
Front view  
Rear view  
Left view  
Right view  
Top view  
Bottom view  
Isometric view  
Perspective projection  

Rotate:

With this command you can rotate the part into any direction.

Pan

With this command you can move the part into any direction.

Zoom

With vertical "navigation" and holding down left mouse-button, change the size: "Up"--> view enlarges"down" --> view decreases.

Zoom view on rectangular clipping Click on the first edge of the section to be enlarged and pull open the rectangle by holding down the mouse-button. When letting go of the mouse-button, this section is zoomed in on.
Zoom all

This command adjusts the size of the part to the window.