powered by CADENAS

Manual

Manual

5.3.12.  Conflicts

Conflicts within the configuration are signalized by red highlighting of all affected parts.

In the following example, a conflict is caused due to a moving along the flute.

The cause are 2 crossing M12 write connections. These may not cross at the same position.

If the movement of the part is pushed all the way to the end position of "280" a conflict will arise.

Moving to end position "280" creates a conflict

Moving to end position "280" creates a conflict

M12 write connection

M12 write connection

Conflict: everything marked in red

Conflict: everything marked in red