powered by CADENAS

Manual

Manual

5.3.2.  Select connection point

Choose a connection point in the 3D area or under Details.

--> The connection point will now be marked in red.

Part information / Choose connection point

Part information / Choose connection point

"Upper side" is marked in red

"Upper side" is marked in red

Choose connection point

Choose connection point

The directory tree for selecting parts is now again shown in the dialog area Details.

Select the part which is to be connected.

On level below the part, the connection points are listed.

Select a connection point (in this figure Front).

Confirm with OK or double-click.

--> Part 2 is inserted.