powered by CADENAS

Manual

Manual

2.3.1.3.3.1. Adjust BOM list attributes

For more complex attribute adjustment, open the Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg in PARTadmin.

Change the key, for example as shown in the following image. See also Section 2.2.1, “Syntax and concepts ”.

NAME=?GetObject("iface.calcnameservice").start(0).Format("Prefix - <ATTR(NB)>").value()

Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg

Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg

The value of the attribute "Name" is now no longer "NB", but "Prefix - NB". Compare Fig. „BOM list enhanced with the attributes "Name" and "Supplier"“.

BOM list attribute "Name" now with "Prefix"

BOM list attribute "Name" now with "Prefix"

[Note] Note

You want to apply more or different attributes than the ones available in the PARTadmin user interface?

General information on applying keys can be found under ???.