Select a Vault project in Inventor. Add "CADENAS" to the library paths. The path to this library should always be local (local hard disk). This corresponds to the pool path:

Enter library path

Afterwards the local library directories of the new project have to be assigned to the respective VAULT directory:

Allocate project directory

Notes for assignment of user rights:

All PARTsolutions user have to be library worker, because new geometries are created by PARTsolutions „On the fly“:

If this is not desired, you can check all PARTsolutions parts in and out via a CADENAS library user. However, this user needs the rights to the library. Registration with this user occurs via PARTsolutions without user interaction (see also Section 5.20.3.2, “ Try NT user authentication ” bzw. Section 5.20.3.3, “ Enable automatic login ”).