powered by CADENAS

Manual

Manual

1.7.5.19.5.12.  Key "TABCONTENT_SEARCHRESULT_DEFAULT_REQUEST_PATH"

You can configure with which selection under Search in PARTdataManager or a new search tab opens .

Search in

  • all catalogs

  • all classifications

  • all native catalogs

  • Special search path

PARTadmin -> category Configuration files -> $CADENAS_SETUP -> partsol.cfg-> block [PARTdataManager] -> key TABCONTENT_SEARCHRESULT_DEFAULT_REQUEST_PATH

Selection options (value range) in the list field:

  • cat: All catalogs

  • cls: All classifications

  • nat: All native catalogs

  • Freely defined path is also possible. Therefor click into the input field and enter the desired path.

    Example: cat/norm/ansi

Default search path or recently used one?

A further setting allows to specify whether the set default search path or the recently used one shall be used.

PARTadmin -> category Configuration files -> $CADENAS_SETUP -> partsol.cfg-> block [PARTdataManager] -> key TABCONTENT_SEARCHRESULT_DEFAULT_REQUEST_PATH_STARTUP

Selection options (value range) in the list field:

  • last: The recently used search path is used again.

  • default: The search path specified in the key TABCONTENT_SEARCHRESULT_DEFAULT_REQUEST_PATH is used.