powered by CADENAS

Social Share

Amazon

Leg mechanism (7365 views - Mechanism & Kinematics)

A leg mechanism (walking mechanism) is an assembly of links and joints (a linkage) intended to simulate the walking motion of humans or animals. Mechanical legs can have one or more actuators, and can perform simple planar or complex motion. Compared to a wheel, a leg mechanism is potentially better fitted to uneven terrain, as it can step over obstacles.
Go to Article

Explanation by Hotspot Model

Youtube


    

Leg mechanism

Leg mechanism

A leg mechanism (walking mechanism) is an assembly of links and joints (a linkage) intended to simulate the walking motion of humans or animals. Mechanical legs can have one or more actuators, and can perform simple planar or complex motion.

Compared to a wheel, a leg mechanism is potentially better fitted to uneven terrain, as it can step over obstacles.[1]

Design goals

  • horizontal speed as constant as possible while touching the ground (support phase)[1][2]
  • while the foot is not touching the ground, it should move as fast as possible
  • constant torque/force input (or at least no extreme spikes/changes)
  • stride height (enough for clearance, not too much to conserve energy)
  • the foot has to touch the ground for at least half of the cycle for a two/four leg mechanism[1] or respectively, a third of the cycle for a three/six leg mechanism
  • minimized moving mass
  • vertical center of mass always inside the base of support[1]
  • the speed of each leg or group of legs should be separately controllable for steering[2]
  • the leg mechanism should allow forward and backward walking[2]

Another design goal can be, that stride height and length etc. can be controlled by the operator.[2] This can relatively easily be achieved with a hydraulic leg mechanism, but is not practicable with a crank-based leg mechanism.[2]

The optimization has to be done for the whole vehicle – ideally the force/torque variation during a rotation should cancel each other out.[1]

History

Richard Lovell Edgeworth tried in 1770 to construct a machine he called a "Wooden Horse", but was not successful.[3][4]

The Plantigrade Machine by Pafnuty Chebyshev was shown at the Exposition Universelle (1878).

Gallery

Stationary

Walking

* 4 legs 6 legs
Strandbeest
Ghassaei
Klann linkage 1
Klann linkage 2
Plantigrade Mechanism
Trotbot[13]
Strider Linkage[12]

Complex mechanism

Shown above are only planar mechanisms, but there are also more complex mechanism:

See also



This article uses material from the Wikipedia article "", which is released under the Creative Commons Attribution-Share-Alike License 3.0. There is a list of all authors in Wikipedia

Mechanism & Kinematics

3D,Geneva double,mechanism,kinematics,rotation,translation