powered by CADENAS

Manual

Manual

2.5.13.2.2. Insert connection from PARTsolutions

In the Connection section you can determine via , whether holes have to be added as parts or not at the export.

The following figure shows the selection of a hexagon bolt and the selection of the hole ISO 273f on bolt and nut side.

Connection with holes

Connection with holes

In the tree view you can see the difference: At bolt 1 the hole has been transferred in addition, at bolt 2 not.

When you hide the bolts you can see the difference in the 3D depiction as well.

Under Section 2.6.12, “ Insert Connection ” you can find a general description of the PARTdataManager Connection section.

Detailed information on the Connection section is found under Section 3.1.12.4, “User interface in detail ”.