powered by CADENAS

Manual

Manual

5.3.3. Set column visible in PARTdataManager

So that the column is shown in PARTdataManager, two requirements must be fulfilled:

  1. Under Modify column display, under Visible the respective column must be set on Yes.

    In the columns Variable DB and Variable the stated column name is displayed.

    The entry under Variable DB is fixed.

    The entry under Variable may be adjusted, if needed.

    [Note] Note

    Please make sure that exactly this name is used for all configurations. (Especially see the two next points.)

  2. In PARTadmin, the column has to be entered in all desired roles under Columns to be displayed.

    [Note] Note

    Please note which Roles is selected on the left side. The column display is always depending on the role.

    [Note] Note

    The position in PARTdataManager is according to the position in the listing.

Save the changes.

-> A message is displayed pointing out that the link database index should be newly created in order to consider the column when searching.

On this see Section 1.1.3.4.5.2, “Context menu commands in detail ”.

PARTadmin -> Index administration

PARTadmin -> Index administration

Result in the PARTdataManager

[Note] Note

In order to get the column to be displayed in the PARTdataManager, you must be logged in with the role assigned to you in PARTadmin.