powered by CADENAS

Manual

Manual

2.3.1.3.3.1. Adjust BOM list attributes

For more complex attribute adjustment, open the Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg in PARTadmin.

Change the key, for example as shown in the following image. See also Section 2.2.1, “Syntax and concepts ”.

NAME=?GetObject("iface.calcnameservice").start(0).Format("Prefix - <ATTR(NB)>").value()

Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg

Category Configuration files -> $CADENAS_SETUP -> ifacad.cfg

The value of the attribute "Name" is now no longer "NB", but "Prefix - NB". Compare Fig. „BOM list enhanced with the attributes "Name" and "Supplier"“.

BOM list attribute "Name" now with "Prefix"

BOM list attribute "Name" now with "Prefix"

[Note] Note

You want to apply more or different attributes than the ones available in the PARTadmin user interface?

General information on applying keys can be found under Section 1.7.1.4.3, “Editing blocks, keys and key values”.