Ellipse by point on main axis and hull edge point :

In the Change parameter window you can adjust the coordinates through values and/or variables.

Ellipse by point on main axis, width and height :

See Ellipse by point on main axis and hull edge point.

In the Change parameter window you can regulate the dimension of the ellipse via Width and Height (see figure at right).

Ellipse by main axis angle, width and height :

See Ellipse by point on main axis and hull edge point

In the Change parameter window you can regulate the dimension of the ellipse via width, height and the angle between the x and main axis (see figure at right).

Ellipse segment by point on main axis, start- and end point :

See Ellipse by point on main axis and hull edge point, then:

-> The segment, which can be found in clockwise direction between a) and b, remains intact!

Start and End point can be adjusted in the Change parameter window.

Ellipse segment by point on main axis, width, height, start- and end point :

See Ellipse segment by point on main axis, start- and end point.

Width and Height can also be adjusted in the Change parameter window.

Ellipse segment by point on main axis, width, height, start- and end angle :

See Ellipse segment by point on main axis, start- and end point.

Start and End angle refer to the main axis. Both can be adjusted in the Change parameter window.

Ellipse segment by main axis angle, width, height, start- and end angle :

See Ellipse segment by point on main axis, start- and end point.

In the Change parameter window you can additionally determine the dimension of the ellipse via the angle between the x and main axis.