Click on „einzelteil-projekt.tac“.

In the dialog area Edit project, click on the Edit button.

In the dialog box Edit file, confirm with OK.

Create the characteristic attribute table/ *.tac file of your part. In this example the cap nut from the "Cap Nut Training" is used. On this compare under Section 3.2, “Example: Creating a cap nut ”.

Save the *.tab or *.tac and close PARTdesigner.

-> In PARTproject the characteristic attribute table of the cap nut is taken as „einzelteil-projekt.tac“. When clicking the Edit button again, the new created table is opened.

-> Later the table will be shown in the Part view of PARTdataManager.