powered by CADENAS

Manual

Manual

6.6.2.10.1.1. Context menu commands

If you want to use the Levels of Detail in PARTdesigner, carry out the command Calculate configuration automatically... " on the uppermost level of the context menu.

Now you can set the desired level of detail in the pull-down menu. The display corresponds to the single steps in the PARTdataManager.

HighThe example figures show ISO 4231High

High[a]High

Medium

Medium

Low

Low

[a] The example figures show ISO 4231

The following commands are made available to you in the uppermost directory level in the context menu:

  • All visible in this configuration

  • All invisible in this configuration

  • Reset all configurations

  • Calculate configuration automatically...

  • Deactivate automatic configurations

  • Copy configuration from

    ...High detail

    ...Medium detail

    ...Low detail

Context menu - Level of Detail

Context menu - Level of Detail