powered by CADENAS

Manual

Manual

4.7.2.1.15.7.  Create standardization system

The standardization system is a special case of classification. In order to add a new standardization system to PARTdataManager, enter

  1. the desired description [19] and confirm with OK. Already contained in the installation, you can find the classification Standards .

  2. Save changes and update your index.

    See Section 1.1.3.4, “ Index administration ” in PARTsolutions / PARTcommunity4Enterprise - Administration Manual.

--> In the part selection of the PARTdataManager on the Classes tabbed page, the new standardization system is displayed. The sub-categorization within Standards is in three steps.



[19] New standardization systems can be applied upon request by CADENAS.